KABU LOCKSIL 1 LTR

Description

DESCRIPTION
KABU LOCK is a 100% Reactive Organosilane Nano – Sealer. When applied on a siliceous substrate, it penetrates up to 2 mm inside the substrate and becomes an integral part of the structure. It converts the nature of the substrate from hydrophilic to hydrophobic. KABU LOCK is water dilutable, safe, sprayable and easy to apply. KABU LOCK acts like a ‘skin’ up to 2 mm deep for your building as against a polymer or paint film that acts like a ‘Band-Aid’ on your Building. The peel-off issues are eliminated as KABU LOCK is non-leachable & UV-Resistant. It has a dual property of preventing of ingress of liquid water while allowing moisture vapors to escape.

FEATURES & BENEFITS
•Novel Bacteria Based self-Repairing Nanotechnology of waterproofing.
•Easy to apply, economical, water repellent property maintained for years (20+years.)
•Breathable coating allows water vapor to pass. Keeps substrate dry. No deuteriation occurs.
•The treated surface turns hydrophobic and no longer allows to penetrate water into cracks. It cannot be wetted by water.
•Reduces thermal conductivity.
•Through capillaries drastic reduction in water uptake.
•Resistant to Abrasion, Thermal, UV.
•No shining, no tackiness, No health risk.
•Environment friendly.

AREAS OF APPLICATION
•Waterproofing Membrane : Roof terraces, sunken portion of toilets & bathrooms, chhajas, balcony, etc.
•Concrete Repairs : Spalled concrete of slabs, chhajas, beams, columns, parapet, floor, etc.
•Waterproofing &/or Bonding Primer : Walls & slabs

METHOD OF APPLICATION
•The substrate should be cured, dry and free from internal voids (honey combs).
•If honey combs are present, drill a hole and inject KABU LOCKSIL solution 1:20 in water. Allow it to dry and then inject a suitable grout to fill and close the hole.
•For substrates with oil, grease, fungal growth etc., clean and dry the surface thoroughly before application.
•It should be diluted with potable water (TDS <1000 ppm) to obtain a clear transparent solution.
•The diluted solution should be liberally sprayed with low pressure until flood saturation is achieved.
•Flood saturation on horizontal surfaces means no further absorption of KABU LOCKSIL even after 5 minutes of saturation.
•On vertical surfaces apply KABU LOCKSIL from bottom to the top to eliminate drip-mark formation.
•To achieve full saturation on vertical surface, after repetitive light spray (3-4 times after 30-45 seconds) the solution should drip down the wall.
•Both applications are best done at a temperature between 10ºC (50oF) to 35ºC (95oF). It is best to do the application during the morning or evening hours to avoid peak heat of the Sun.
•For doing any Screeding / Plastering / Tiles / Paint Work on the treated surface, KABU BOND (Acrylic Binder) must be added to the KABU LOCKSIL Solution during preparation in the recommended ratio of 2 parts of KABU BOND 1 part of KABU LOCKSIL & 20 parts of water.